Burntech BOFP-48P Installationshandbuch PDF herunterladen (Seite 21)

TROUBLESHOOTING (

Continued)

WARNING: If you smell gas

• Shut off gas supply.

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire department.

IMPORTANT: Operating fire ring where impurities in air exist may create odors. Cleaning supplies, paint, paint remover,

cigarette smoke, cements and glues, etc., create fumes. These fumes may mix with combustion air and create odors. These

odors will disappear over time.

OBSERVED PROBLEM

POSSIBLE CAUSE

REMEDY

Burner is excessively noisy

(Note: The movement and com-

bustion of gas will create low,

unavoidable levels of noise.)

1. Passage of air/gas across

irregular surfaces

2. Excessive flame impingement or

blockage

1. Relieve any tight bends or kinks

in gas supply line

2. Check/reset gas regulator

pressure

Gas odor even when control knob

is in OFF position

1. Gas leak. See Warning at top of

page

2. Control Valve defective

1. Locate and correct all leaks

(See Checking Gas Connections,

page 7)

2. Replace control valve

Gas odor during combustion

1. Gas leak. See Warning at top of

page

1. Locate and correct all leaks

(See Checking Gas Connections,

page 7)

Fire ring produces a

clicking/ticking noise just after

burner is lit or shuts off

1. Metal expanding while heating or

contracting while cooling

1. This is normal. If noise is

excessive, contact qualified service

person

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Burntech BOFP-48P Installationshandbuch Seite 21

Kommentare zu diesen Handbüchern