Burntech BOFP-48P Installationshandbuch PDF herunterladen (Seite 5)

INSTALLATION

WARNING: A qualified service person must

install appliance. Follow all local codes.

NOTICE: State or local codes may only allow

operation of this appliance in a vented con-

figuration. Check your state or local codes.

CHECK GAS TYPE

Use the correct type of gas (natural or propane/LP). If

your gas supply is not the correct gas type, do not

install appliance. Call dealer where you bought

appliance for proper type appliance.

WARNING: This appliance is equipped for either

natural gas or propane/LP gas but not both. Gas

type is indicated on the rating plate. Field

conversion is not permitted.

INSTALLATION AND CLEARANCES

WARNING: Maintain the minimum clearances. If

you can, provide greater clearances from floor

and adjoining wall.

MINIMUM CLEARANCE TO COMBUSTIBLE

MATERIALS

Side Wall 16",

Bottom: 0" (For Wood Burning Installation- Non-

Combustible Floor is Required)

WARNING: DO NOT PLACE UNDER A CEILING

OR OVERHANG.

CONNECTING TO GAS SUPPLY

WARNING: This appliance requires a 1/2"

NPT (National Pipe Thread) inlet connection

to the pressure regulator.

WARNING: A qualified service person must

connect appliance to gas supply. Follow all

local codes.

CAUTION: Never connect propane/LP fire

ring directly to the propane/LP supply. This

appliance requires an external regulator (not

supplied). Install the external regulator be-

tween the appliance and propane/LP supply.

WARNING: Never connect natural gas

fire ring to private (non utility) gas wells.

This gas is commonly known as

wellhead gas.

Installation Items Needed

Before installing appliance, make sure you have

the items listed below.

• external regulator (supplied by installer)

• piping (check local codes)

• sealant (resistant to propane/LP gas)

• equipment shutoff valve *

• test gauge connection *

• sediment trap

• tee joint

• pipe wrench

• approved flexible gas line with gas connector

(if allowed by local codes) (not provided)

* An equipment shutoff valve with 1/8" NPT tap is

an acceptable alternative to test gauge

connection. Purchase the optional equipment

shutoff valve from your dealer.

For propane/LP units, the installer must supply

an external regulator. The external regulator will

reduce incoming gas pressure. You must reduce

incoming gas pressure to between 11" and 14" of

water. If you do not reduce incoming gas

pressure, appliance regulator damage could

occur. Install external regulator with the vent

pointing down as shown in Figure 2, page 6.

1 2 3 4 5 6 7 8 9 10 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Burntech BOFP-48P Installationshandbuch Seite 5

Kommentare zu diesen Handbüchern