Burntech BOFP-48P Installationshandbuch PDF herunterladen (Seite 17)

INSTALLATION/OPERATION (Wood Burning)

Wood Burning:

The Burntech Fire Ring is able to burn wood instead

of Natural/Propane Gas. The Installation process is

shown below. (For Wood Burning Installation-

Non-Combustible Floor is Required) (note: Wood

Burning installation does not include Half Block

Door, Brackets or burner system.)

1. Locate a flat even surface to build your fire

ring. See Specifications page 4 for sizing and

Minimum Clearances page 5 when selecting a

location.

2. Use 8 blocks to build the first layer (See

Figure 6). After laying out all blocks, using a

level, verify all the blocks are level. Shim if

necessary.

3. When starting second layer, stagger blocks to the

first layer (see Figure 8). For the BOFP24-48, use 8

blocks to build the second layer. After laying out all

blocks, using a level, verify all the blocks are level.

Shim if necessary.

4. When starting the top layer, stagger blocks to the

layer below. Use 8 full blocks). After laying out all

blocks, using a level, verify all the blocks are level.

Shim if necessary.

5. Next be sure to line the inside with firebrick to

help radiate the heat out of the Fire Ring.

Starting the Fire:

Start the first fire slowly with a small amount of

paper and kindling (small dry wood splits or twigs)

stacked in a crossed or teepee fashion toward the

center. Slowly add small but larger pieces of dried

hardwood of about three inches (2”) to four inches

(4”) diameter. The temperature will begin to rise in

your Fire Ring however it may take about 15

minutes to begin a faster temperature ascent.

NOTE: Take care not to feed your fire too fast so as

to smother it. As you add more wood, a temporary

decrease in temperature my occur. This is normal

and as soon as the new wood begins to burn, your

temperature will rise.

The next step is to ensure that your fire continue to

build.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

Keine Kommentare

Burntech BOFP-48P Installationshandbuch Seite 17