OWNER’S OPERATION AND INSTALLATION MANUAL FIRE RING MODELS BOFP16-48 AND BOFP24-48 NATURAL GAS BURNER MODELS: BOFP-48NG PROPANE/LP GAS BURNER MOD
10 INSTALLATION (Continued) 3. When starting second layer, stagger blocks to the first layer (see Figure 8). For the BOFP24-48, use 8 blocks to
11 INSTALLATION (Continued)WARNING: Heat shield must be installed. 7. Place heat shield on the retaining brackets in thecenter of the fire ring (see F
13 INSTALLATION (Continued)12. Place concrete cap on the top layer of blocks.Center cap on block. Level and shim if necessary (See Figure 16). 13. In
14 OPERATIONFOR YOUR SAFETY READ BEFORE LIGHTING WARNING: Keep flue open when operating unit. WARNING: If you do not follow these instruc-tions
15 OPERATION (Continued)TO TURN OFF GAS TO APPLIANCE 1. Turn control knob clockwise to the PILOTposition. 2. Press in and turn control clockwi
16 BURNER FLAME PATTERN Burner flames will be steady, not lifting or floating. Flames should go up through middle of the fire ring burner in a
17 INSTALLATION/OPERATION (Wood Burning)Wood Burning: The Burntech Fire Ring is able to burn wood instead of Natural/Propane Gas. The Installation pro
18 CLEANING AND MAINTENANCEWARNING: Turn off appliance and let cool before cleaning. CAUTION: You must keep control areas, burners and c
19 TROUBLESHOOTING WARNING: Turn off appliance and let cool before servicing. Only a qualified service person should service and repair
2 TABLE OF CONTENTS Safety...2 Local Codes...
20 TROUBLESHOOTING (Continued) OBSERVED PROBLEM POSSIBLE CAUSE REMEDYPilot lights but flame goes out when control knob is released 1. Contol knob not
21 TROUBLESHOOTING (Continued) WARNING: If you smell gas • Shut off gas supply.• Do not try to light any appliance.• Do not touch any electrical switc
22 PARTS BURNER MODELS BOFP-48NG, BOFP-48P
23 PARTS This list contains replaceable parts used in your appliance. When ordering parts, follow the instructions listed under Replacement Parts on p
24 PARTS
25 REPLACEMENT PARTS Note: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warrant
26 Limited Warranty Fire Ring Burntech Fireplace Solutions warrants all Burntech manufactured products to be free from defects in materials that adver
3 SAFETY (Continued) 1. This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible f
4 SPECIFIATIONS Figure 1 – BOFP16-48 AND BOFP24-48 BOFP-48NG • Rating: 96,000 Btu/hr • Gas Type: Natural Gas Only • Ignition: Manual • Manifold Pr
5 INSTALLATION WARNING: A qualified service person must install appliance. Follow all local codes. NOTICE: State or local codes may only
6 Pointing the vent down protects it from freezing rain or sleet. www.burntech.com INSTALLATION (Continued) CAUTION: Use only new, black iron or s
7 INSTALLATION (Continued) CHECKING GAS CONNECTIONS WARNING: Test all gas piping and connec-tions, internal and external to unit, for
9 INSTALLATION (Continued)GAS LINE PLANNING The supply line will need to run vertical through the heat shield in the center of the fire ring up to whe
Kommentare zu diesen Handbüchern