Burntech BOFP-48P Installationshandbuch PDF herunterladen (Seite 3)

SAFETY (Continued)

1. This appliance is only for use with the type of gas

indicated on the rating plate. This appliance is not

convertible for use with other gases.

2. Do not place propane/LP supply tank(s) inside or

under the fire ring. Locate propane/LP supply

tank(s) at least 10 feet away (propane/LP units

only).

3. If you smell gas

• shut off gas supply

• do not try to light any appliance

• do not touch any electrical switch; do not use

any phone in your building

• immediately call your gas supplier from a neigh-

bor’s phone. Follow the gas supplier’s instruc-

tions

• if you cannot reach your gas supplier, call the

fire department

4. To prevent the creation of soot, follow the instruc-

tions in Cleaning and Maintenance, page 14.

5. Do not run appliance

• where flammable liquids or vapors are used or

stored

• under dusty conditions

6. Do not use this appliance to cook food or burn

paper or other objects.

7. Do not use this appliance if any part has been

exposed to or under water. Immediately call a

qualified service technician to inspect the room

appliance and to replace any part of the control

system and any gas control which has been un-

der water.

8. Turn appliance off and let cool before

servicing, installing or repairing. Only a qualified

service person should install, service or repair

appliance.

9. This appliances must not be connected to any

external electrical source.

10.Operating appliance above elevations of 4,500

feet may cause pilot outage.

17.To prevent performance problems, do not use

propane/LP fuel tank of less than 100 lb. capacity

(propane/LP units only).

18.Provide adequate clearances around air open-

ings.

LOCAL CODES

Install and use appliance with care. Follow all local

codes. In the absence of local codes, use the latest

edition of The National Fuel Gas Code, ANSI

Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

UNPACKING

1. Remove burner system and other components

from box. Do not grasp by burner tubes. If it is

evident that the burner is damaged, it must be

replaced prior to being put into operation. Set

lava rock boxes aside for further instruction.

2. Remove all protective packaging from pallet of

blocks for shipment.

3. Check for any shipping damage. If appliance is

damaged call Burntech Fireplace Solutions at 1-

818-564-4225 for replacement parts before

returning to dealer. www.burntech.com

1 2 3 4 5 6 7 8 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Burntech BOFP-48P Installationshandbuch Seite 3

Kommentare zu diesen Handbüchern